Clean and Press

Instructions

Assume a shoulder-width stance, with knees inside the arms. Now while keeping the back flat, bend at the knees and hips so that you can grab the bar with the arms fully extended and a pronated grip that is slightly wider than shoulder width. Point the elbows out to sides. The bar should be close to the shins. Position the shoulders over or slightly ahead of the bar. Establish a flat back posture. This will be your starting position.
Begin to pull the bar by extending the knees. Move your hips forward and raise the shoulders at the same rate while keeping the angle of the back constant; continue to lift the bar straight up while keeping it close to your body.
As the bar passes the knee, extend at the ankles, knees, and hips forcefully, similar to a jumping motion. As you do so, continue to guide the bar with your hands, shrugging your shoulders and using the momentum from your movement to pull the bar as high as possible. The bar should travel close to your body, and you should keep your elbows out.
At maximum elevation, your feet should clear the floor and you should start to pull yourself under the bar. The mechanics of this could change slightly, depending on the weight used. You should descend into a squatting position as you pull yourself under the bar.
As the bar hits terminal height, rotate your elbows around and under the bar. Rack the bar across the front of the shoulders while keeping the torso erect and flexing the hips and knees to absorb the weight of the bar.
Stand to full height, holding the bar in the clean position.
Without moving your feet, press the bar overhead as you exhale. Lower the bar under control .

Frequently asked questions

What muscles does the Clean and Press work?

Clean and Press primarily targets the Shoulders. It also engages the Abdominals, Calves, Glutes, Hamstrings, Lower Back, Middle Back, Quadriceps, Shoulders, Traps, Triceps as secondary muscles. This makes it an effective strength exercise for building shoulders development.

What equipment do I need for the Clean and Press?

You will need a barbell to perform the Clean and Press. Make sure the equipment is set up properly and at the appropriate weight before starting.

Is the Clean and Press suitable for beginners?

The Clean and Press is an intermediate exercise. You should have a solid foundation of basic strength movements before attempting it. If you're new to training, start with simpler variations and progress to this exercise as your form and strength improve.

Is the Clean and Press a compound or isolation exercise?

The Clean and Press is a compound exercise, meaning it works multiple joints and muscle groups simultaneously. Compound movements are efficient for building overall strength and are typically performed earlier in a workout when you have the most energy.

How many sets and reps should I do for the Clean and Press?

For strength, aim for 3-5 sets of 5-8 reps with heavier weight. For muscle building (hypertrophy), try 3-4 sets of 8-12 reps at a moderate weight. For endurance, use lighter weight and perform 2-3 sets of 15-20 reps.

What are good alternatives to the Clean and Press?

Good alternatives include the Alternating Cable Shoulder Press, Alternating Deltoid Raise, Alternating Kettlebell Press. These exercises target similar muscle groups (Shoulders) and can be substituted based on available equipment or training preference.

Track this exercise